Decks.com. Free Standing Decks

A free standing deck is a self supporting deck structure built independently from a house wall ledger board attachment. After you realize you want a deck, the next step is to figure out exactly where you want to put one and how big it should be. Take a couple chairs and/or a table out where you’ll want to place a deck in your yard and figure out how much space you’ll need around it. You might want to try marking the area off with a garden hose and living with it for a couple days to see if it works.

This can be especially helpful if you own an older home, that shouldn’t bear any more weight than it already is. When a deck is built attached to a house, your home is responsible for supporting half of the weight of the deck, furniture, and people who are on it. This type of deck can be built to appear that it is attached to your home so to the naked eye you would never know it wasn’t attached.

Your local hardware store will be a great place to gather supplies and gather any information you need about your specific deck building project. This application guide provides information on the specification, design, and construction of timber decks used for domestic purposes. If you build it away from the house, plan access to the deck via a path or walkway. In termite country, check older decks for mud tunnels leading from soil over concrete footings to the wood. Mark the length and position of the deck on the wall of your house with a pencil.


When deck boards run all the way to the edge of the porch and walls are then built directly on top of them, replacing damaged or rotten decking is a headache. You practically have the deck built and this is the downhill towards the finish. The two outer square timbers are upright and aligned on the outside edge, while the centre square timber is positioned in the middle of the base planks.

My main reason for building a free standing deck rather than an attached deck was that I had read so many articles about the rot that occurs where a deck attaches to a building. Shim here and there if needed and once you are sure all joists are level and even with one another, may need a building inspection before proceeding. This step is usually taken on the grounds that they can extend the life of your deck significantly. Most timber decking in Australia is now sold with machined ridges on the under side.

And I am afraid that means you must install proper concrete footing foundations that go below frost line so the deck doesn’t move independently in relation to the home. Also, there are two types of deck blocks: one where the deck framing gets set into/rests on top of the blocks in a slot that has been formed in the blocks; and another where there is a 4×4 post base is set into the block.

The results page also has a materials list showing how much wood to order and how many deck piers will be required. A deck affixed to the side of your home can use your home for support on that side. Most professional builders will use the notching method because it produces a better quality deck. How to make a deck, safety first, select metal fixings, 10 top tips, building your deck, care and maintenance, fitting balustrades, build steps and stairs, build deck over existing patio, low level deck and elevated deck – post and beam construction. An interesting loophole might exist in some zoning codes if you design the deck so it does not attach to the house.

If the deck you are planning projects more than 2 metres from the building then it is recommended that additional expert advice be sought from your Local Authority or an appropriately qualified expert. Free-standing decks also have the disadvantage of needing structural support on each side of the deck. In the past if a home owner wanted to waterproof a lower deck ‘Colorbond’ was fixed to the underside of the upper deck. The plans for building this deck are available free of charge from DekBrands, the company that sells Dek-Block piers.