The Global Ecotherm Industrial oven offers the best heating technology for a quick, tension free and flawless heating process of acrylic Solid Surface materials and is also ideally suited for preheating thermoplastics and similar composite materials. I’m new to the woodworking forums, but have been reading alot of posts and information regarding chip and dust collection for small workshops. Most of the veneering books and articles I have read are just too complicated and are geared toward proprietary materials and equipment. And while those systems draw most of the air out, which is enough to collapse blankets and pillows, I don’t think the vacuum is as close to a true vacuum as you’d need it to be. I can’t be 100% sure though since I never tried it. But that’s what my gut is telling me.
You will find that this system is very versatile, allowing you to complete turnings with exquisite details on the bottom of vessels or even to complete whole turnings. I did experiment a bit with a venturi design using compressed air to get a vacuum. The little manual pump we use at sea level will not generate 14.7 pounds of pressure. In a similar way, a vacuum press can be used to clamp useful router jigs to your project blanks. You can use one of your handy clamps listed previously and clamp the hose to your saw, vacuuming up the sawdust as it’s made.
If you’re looking for raw CFM’s and you will be pulling a lot of dust and chips through your system or you will have long pipe runs then a dust collector should be considered. I opted for a Dust Deputy separator for my system but there are several out there to choose from. Low Cost – Make your own basic or unique vacuum jigs to handle day to day operations or special projects.
If you don’t have an auto-start vacuum, one useful tool that can perform the same function is called the i-Socket What this small device does is plug into any standard electrical outlet, and has two plug-in sockets: one for a tool, and another for the vacuum. The membrane presses of VP series are optimal solution for woodworking and a furniture production from all types of wood. My pump experience goes no further than the model I have, which I purchased from some wholesale place years ago.
If you will be running two machines at the same time, then your system will need to handle the combined CFM requirements of both machines. The number of tools was a concern however because I will most likely want more than one tool hooked up to the system at a time. If a caul was not used on top of the veneer (bag directly on the veneer), this could be the cause of wrinkles. The Big Brute Popular Industrial Vacuum Cleaner is powerful enough to gulp up wood shavings, saw dust and small lumps of wood.