How To Apply Wood Stain Sprays With A HVLP Sprayer

Instead of trying to answer all these questions in one pass, let’s will focus on how to apply wood stain spray using a HVLP (high volume, low pressure) sprayer. An easy test is to fit the regulator and set the spraying pressure (the regulator will have a pressure gauge on it) then run your spray gun with water in it. Watch the pressure gauge on the compressor and if this pressure falls below the set pressure on the regulator then your compressor isn’t up to it. You may be able to still use the unit as a spray outfit but you will need to stop spraying longer and let the compressor catch up.

Savings of expensive paint material achieved with an HVLPHVLP = High Volume Low Pressure – low spray pressure technology.Terminology for an internationally recognized low-pressure technology whereby the transfer efficiency rate has to exceed 65%, while the maximum air cap pressure is below 0.7 bar.X» gun by far compensate the slight additional cost provoked by the higher air consumption.

It is also important to know that the higher air consumption has practically no influence on the profitability of an HVLPHVLP = High Volume Low Pressure – low spray pressure technology.Terminology for an internationally recognized low-pressure technology whereby the transfer efficiency rate has to exceed 65%, while the maximum air cap pressure is below 0.7 bar.X» paint spray gun.

Most of the spraying has been with water based paint (Dulux trade primer, and both Satin and Gloss top coat) all Trade paint not the watery diy stuff, i have blasted a couple of table tops with a polyurethene satin laquer and that went really well very supprised with the finish it needed only a small amount of de-nibbing between coats, a bit smelly though.

And, if after that, you’re unsure about something, give Fuji a call or send them an email through their contact page The folks at Fuji are extremely easy to deal with, (I’m speaking from firsthand experience here) not only are they friendly and very knowledgeable, they honestly want you to succeed in spray finishing and they work hard to do just that.

Although there are very expensive ($450+ US) guns in this category available, such as the Binks and Sata, there are also some excellent choices available in the $100-250 range, including the object of this review…the Wagner HVLP Conversion Gun which sells for $129 from Gleem Paint The next step up (and not a small one) would be something like the Asturo BRI/A guns offered by Homestead Finishing Products for about $350.

DSI carries a large stocking inventory of: Plywood & Hardwood Lumber , TFL Melamine & Composite Panels ( Particle Board & MDF ), High Pressure Laminates , M.L. Campbell Wood Finish & Stains , Solid Surface Products and other complimentary woodworking supplies Product expertise, outstanding customer service, and prompt delivery always accompany your purchase.hvlp spray gun for woodworking