Wood Lathe & DIY Woodturning Projects

Wood turning is fast becoming a popular hobby for woodworkers of all skill levels. A workpiece may be mounted on a mandrel , or circular work clamped in a three- or four-jaw chuck For irregular shaped workpieces it is usual to use a four jaw (independent moving jaws) chuck. Dead center – noun A cone center that goes in the tailstock spindle of a lathe but which does not revolve with the work. Scrapers have to be kept very sharp to avoid crushing the wood instead of scraping it cleanly. The workpiece should not extend too far from the work holding device without adequate support. You will also learn how to safely use the lathe to spin metal using wooden tooling.

Rotate the job through 360 degrees by hand, then start the lathe at its slowest speed to allow you to check that everything is secure. Most lathes will be equipped with a Morse taper in the headstock spindle and the tailstock, these are standard sizes and designated by numbers, the smallest will be a # 0 MT, most hobby lathes will not use anything above a # 3 MT. To start I’m pretty sure that metal lathes and wood lathes have different speeds they tend to use.

Mid 1950s Craftsman Ball-bearing spindle wood-turning lathe with the optional bed-extension piece in place. I would expect it would be fine to turn aluminum or brass on a wood lathe but I’ve always wondered about what repeatedly turning steel would do to the headstock on a wood lathe. Charnwood w 812 wood lathe ,multi speed,on stand ,with extras,great used condition,fully workingwith quality british steel UP OR OVERSEAS BIDS.THANKS.

Lathe tool bit shapes can be pointed, rounded, squared off, or irregular in shape and still cut quite well as long as the tool bit angles are properly ground for the type of material being machined. These power tools are also made to operate at varying speeds depending on what your needs are and what effects on the piece of wood you want to produce as you shape it quickly into whatever final product you wish to get. Chuck manufacturers make chucks to fit almost any lathe’s spindle size and thread count, so buy the chuck that fits the spindle of your lathe.

Weight: A heavier lathe will usually be more stable and will not need additional sandbags or weights to keep it in place. However, the metal keys still need to be ground to different shapes to achieve different profiles, so there is still plenty of cost associated with the metal lathe tools. Tenon tools can be useful to get a nice, clean, sharp and accurate 90 degree inside angle corner for delicate turnings. Experienced machinists have found the following shapes to be useful for different lathe operations.

Precision combination chuck – A once-popular proprietary chuck with attachments which can perform many of the functions performed by other chucks because it includes both expanding or contracting collets. Lathe dogs are cast metal devices used to provide a firm connection between the headstock spindle and the workpiece mounted between centers. We guarantee our Hand Tools to be free from defects in material and workmanship for the life of the product. As a safety note, never use the side of the grinding wheel to grind a tool bit, as this could weaken the bonding of the wheel and cause it to crack and explode.

For beginners, it’s desirable to have a lathe with a big red button labeled Stop” so that you have a failsafe or a method of turning off the lathe during emergencies; it’s like a reset button in a sense. With the turned piece completed you will need to remove the item from the chuck and inspect it against the original. Continue pushing the tool into the stock gradually, in passes, so that you remove a roughly equal amount of wood with each pass.

Bowl gouges also have more variants than any other tool, and one should ask experienced workers what makes one better than another for specific jobs. This chuck combines the functions of the standard collet chuck and drawbar into one single compact unit. Before mounting lathe centers in the headstock or tailstock, thoroughly clean the centers, the center sleeve, and the tapered sockets in the headstock and tailstock spindles. Use light cuts and finishing feeds, which will reduce the tension put on the half male center. Pole lathe – An old-style human-powered lathe used for spindle turning green wood.