Firelogs Vs. Wood Fires

Premium quality gas fireplaces , gas inserts , wood fireplaces , wood inserts , electric fireplaces , and electric inserts by Fireplace Xtrordinair are chosen by many for our wide selection — each custom-crafted with an artful eye for stylish detail. Actually it is a hyped point – All burning produces some level of carbon monoxide, including the gas burners on your typical kitchen stove. It’s virtually impossible to get logs to light in a fireplace without first getting the fire started with much smaller bits of wood. Masonry fireplaces without a glass fire window only provide heat radiated from its surface.

The bigger wood takes a while to catch fire, but once it does, it will burn a long time without you having to get up and stir it or move it around. Three or more pieces are needed to form a sheltered pocket of glowing coals that reflect heat toward each other and sustain the fire. Priming the flue involved warming it up so that cold air from outside doesn’t mix with the warm air of the fire. Do it gradually and keep an eye on the fire – if it dies right back and you start to see smoke in the firebox then you know you have gone too far or done it too soon.

I’m an old fashioned kind of guy but my fire place insert and stainless chimney pipe run up the flu along with thermostatically controlled blowers sure is nice. We cannot offer the factory replacement grate, but any of our fireplace grates that will fit inside your fireplace should be suitable for use. Cleaning out the inside of a wood stove with a wire brush periodically will also help the wood-burning appliance heat more efficiently.

To build a flash fire, rake the charcoal towards the air inlets and place several small pieces on and behind it. The pieces should be stacked loosely in a crisscross arrangement. Much more heat – Once it’s about 3/4 through the shingle wood — in my example sequence above — it will start to give off a LOT of heat. Unlike a moderately drafty home, a house that is relatively air tight may not be able to supply enough outside air to the fire resulting in a negative pressure in the home. As long as there is solid wood in the firebox, there must be flames or the smoke will escape unburned, both reducing efficiency and increasing pollution.

I have a very finicky fireplace in my house, and I could not get the smoke to go UP the chimney for 2 years. This way, the fire grows hotter and hotter and it gradually works its way down to consuming the larger pieces of wood, and you’re left with a hot base of large logs on which you can stack new wood. Many people come into our store to purchase gas logs because their fireplace smokes with wood. We layered the big pieces of wood in a criss cross fashion as kind of a platform and then on the very top, we built a tiny little teepee fire. To build a long-lasting fire, rake the coals towards the air inlet and use larger pieces of wood placed compactly in the firebox behind the coals.

You may be able to simply knock it over with your hands or force your weight upon it with your shoulder – and drag the wood over to the fire area. Brick-chimney fireplaces are the most traditional wood burners, but are also the least efficient, with only about 5-10% of the energy used going towards heating the room. I guess I don’t remember seeing anything on overloading the insert when we had ours installed.

Once these larger logs have caught fire well – probably in around 10-15 minutes – you should then be able to start to turn the air controls down a bit. Heat, fuel and air (or oxygen) are referred to as the fire triangle” or combustion triangle.” These three ingredients are the recipe for fire. If you are referring to an Ecofan, the surface temperature of your gas stove will not be hot enough to operate an Ecofan designed for wood stoves.

Many people close the damper in summer when the fireplace is not being used, and also in winter to prevent cold air from entering the room via the chimney. If the damper is closed too soon a smoldering fire still produces combustion gases which contain carbon monoxide. All species of wood have similar heat (Btu) content on a per pound basis when completely dry. In a fireplace, keep the top of the flames visible below the fireplace opening.how to build a fire in a fireplace insert

They are also the very best for beautiful and functional fireplace cooking accessories including fireplace grills, rotisseries, cranes, and utensils as well as fire pits and other fire and fire cooking related accessories. Deal with the first requirement by positioning your fireplace near the propane or natural gas line, or in a room to which it would be both feasible and cost-effective to run an extension. The cost including labor and materials for our outdoor stone fireplace was approx. I’m burning kiln-dried hardwoods only, and have to feed the fire often, even when the controls are set to a slow burn rate.

If you choose to build a new fireplace and want it to be stone or brick, that will require the work of a mason to do the stone and bricklaying in addition to the contractor doing the fireplace installation. The greater the temperature differential from the inside room temperature and the outdoor temp, the better the fire will draft. Ken, this article talks about starting dry pieces of wood, not wet, but you did hit on things I use to start a fire when wood is wet.